Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Ruston Roofing & Maintenance — leak-free skylight installation in Ruston.
The curb is the foundation of every skylight installation. We frame it between existing trusses or rafters with doubled lumber to carry the load. The roof deck opening is cut precisely — no oversizing that weakens the sheathing. The skylight flange seals to the curb, and the flashing system integrates the unit into the existing shingle field so water runs over the flashing, not under it.
Our Skylight Installation Process
Free Consultation
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Roof Opening & Framing
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Weather Barrier
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Final Seal & Trim
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Ruston Customers Say
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
"From the first phone call to the final walkthrough, everything was seamless. The team was courteous and efficient. Already recommended them to two friends."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
Why Choose Ruston Roofing & Maintenance for Skylight Installation?
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Code Compliant
Every skylight installation meets LA building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Roofer-Installed, Not Handyman
Ruston Roofing & Maintenance is a roofing contractor, not a general handyman. Skylights are roof penetrations — they require roofing expertise, proper flashing materials, and waterproofing knowledge. That's what we do every day.